ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||26 December 2006|
|PDF File Size:||3.79 Mb|
|ePub File Size:||4.31 Mb|
|Price:||Free* [*Free Regsitration Required]|
Link to Active This link will always route to the current Active version of the standard.
Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging. Sheet and Strip can be cold rolled to higher strength.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
The material shall be atsm in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections. Historical Version s – view previous versions of standard. Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost. Looking for some xstm information? Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein.
Offer on Fasteners Sitemap. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Nickel 200® & Nickel 201®
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part.
AlloyAlloy Brand: Siddhagiri Metals and Tubes Manufacturer: In plate atsm, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling. These sheets are made by rolling process.
Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and compressive conditions, without altering the sheet thickness. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
This abstract is a brief summary of the referenced standard. Siddhagiri Metals and Tubes Rating: For deep 1b62 and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.